Author Topic: Brake specialists Sydneys west FINALLY SOLVED (Read 14083 times)

mattlea1 · « **Reply #10 on:** February 11, 2010, 07:59:56 AM »

I have had the car for about 5 years and it has always had it but it started out very minor and has progressively gotten worse over time. I thought the line may be blocked as well but both sides bleed just fine ie: minimal pedal pressure required and fluid flows freely.

sms777 · « **Reply #11 on:** February 11, 2010, 01:14:36 PM »

I would be looking over the suspension again very carefully.
You may have replaced all your bushes but one of your control arms may have a small crack or slight bend in it that would cause it to flex or bend under heavy braking resulting severe bumsteer condition.
Other issue could be your flexible brake line could have collapsed which you will never see from the outside, so replace them with braided ones see how you go.

If it all fails bring it to my work and i will go over it and give my advice free of charge.

bonnevista · « **Reply #12 on:** February 11, 2010, 02:23:38 PM »

Matt, I'd even go one step further than Chris and say have a look at possible cracking in the chassis.

I speak from personal experience.

The combination of RHD conversion and old age can do some funny things.

Steve · « **Reply #13 on:** February 12, 2010, 06:12:32 PM »

be interesting to see what happens when you put the car in reverse and hit the brakes hard ........if it pulls the opposite way then have a really good look at the lower control arms/chassis

Steve · « **Reply #14 on:** February 28, 2010, 07:49:55 PM »

any updates on the brakes ?

mattlea1 · « **Reply #15 on:** February 28, 2010, 09:45:15 PM »

I had the car up on 4x stands on Thursday night and I think I may have nailed the problem, I will know for sure later this week so stay tuned.

Steve · « **Reply #16 on:** February 28, 2010, 10:15:54 PM »

Quote from: mattlea1 link=topic=2941.msg17420#msg17420

I had the car up on 4x stands on Thursday night and I think I may have nailed the problem, I will know for sure later this week so stay tuned.

sounds interesting !

bonnevista · « **Reply #17 on:** February 28, 2010, 10:16:36 PM »

And what sort of nails did you use??

sms777 · « **Reply #18 on:** February 28, 2010, 10:28:13 PM »

Quote from: bonnevista link=topic=2941.msg17422#msg17422

And what sort of nails did you use??

Hmmmmmm......

mattlea1 · « **Reply #19 on:** March 05, 2010, 11:04:01 PM »

Well guys the problem has been sorted once and for all. I was always certain it was not a brake problem but after speaking with many suspension specialists I was told no way would it be a suspension problem. It was all caused by a bent rear sway bar link. When it was fitted to the car it did not stand out as being bent but what was happening was as you applied the brakes the rear of the car lifts and as the sway bar links were effectively two different lengths it would pull the diff at an angle and cause the car to rear steer.

[IMG=700x525]http://i247.photobucket.com/albums/gg160/mattlea1/transam002.jpg[/IMG]