Author Topic: New Motor (Read 5065 times)

chris67 · « **on:** May 04, 2010, 12:29:12 AM »

The new motor is finally complete and im installing it on thursday if all goes well

cpu · « **Reply #1 on:** May 04, 2010, 12:53:46 AM »

Nice. Don't drop it for god sake.

Some friendly advise if I may. Take the rotor button off of the dissy and place a plastic bag over the dissy and the carbie while dropping the engine in.

LeighP · « **Reply #2 on:** May 04, 2010, 08:14:51 AM »

Good luck, the engine looks terrific.

I'm surprised you can fit it complete....you'd never get a fully assembled engine like that into a Firebird.

heven67 · « **Reply #3 on:** May 04, 2010, 12:28:35 PM »

Hey Shmickoo, looks great, I wish I had a new one to put in too!
Luvhev

chris67 · « **Reply #4 on:** May 04, 2010, 05:40:52 PM »

rotor button and carby will be covered before install thats for sure

when its all ready then its off to chris at sms for a tune on the dyno:rub:

heven67 · « **Reply #5 on:** May 04, 2010, 08:49:52 PM »

Quote from: chris67 link=topic=3199.msg18929#msg18929

when its all ready then its off to chris at sms for a tune on the dyno:rub:

Thats probably not a bad Idea, I pick my baby up tomorrow!

Garrett · « **Reply #6 on:** May 06, 2010, 08:08:55 PM »

Looks AWESOME whats the details?

69DirtyRat · « **Reply #7 on:** May 06, 2010, 08:12:48 PM »

Dyno results??

chris67 · « **Reply #8 on:** May 06, 2010, 10:56:21 PM »

no dyno results yet

should have 320 - 330 hp at the rear wheels any more would be a bonus

Bumblebee · « **Reply #9 on:** May 07, 2010, 07:21:29 AM »

You'll have plenty of fun with that Chris, mine's got 315 rwhp and it's quite "adequate".

Best wishes with the ride.

Author Topic: New Motor (Read 5065 times)

cpu

Garrett

Bumblebee